Water Features

How to unclog a water fountain?

Fix a clogged garden or pond fountain by unplugging the pump, cleaning the intake and impeller, clearing tubing and nozzles, and testing the flow.

On this page
  1. What the symptoms tell you
  2. Check the easy things first
  3. Clean the pump
  4. Clear the tubing and nozzles
  5. When the pump hums but won’t move water
  6. Reassemble and test
  7. Prevent clogs
  8. Drinking fountains are a different job
  9. Common mistakes
  10. Safety

To unclog a garden or pond fountain, unplug it, remove the pump, and rinse the intake screen. Clean the impeller, clear the tubing and nozzle holes, then reassemble with the pump fully submerged and test it. If the pump hums but no water comes out, the impeller is probably jammed.

What the symptoms tell you

  • Weak or uneven spray usually means a partly blocked intake, nozzle or tube.
  • Gurgling or sputtering often means air in the line, low water, or a leak at a joint.
  • A pump that hums but moves no water is usually jammed by scale or debris, or its shaft is broken.
  • A pump that stops may be overheating, blocked or out of water.

Check the easy things first

Before you take the pump apart, check three things:

  • Water level. Low water lets air into the pump and causes sputtering. Top it up to the level the maker recommends.
  • Tubing. Look for kinks where the line bends.
  • Nozzle holes. Look for debris, algae or mineral scale blocking them.

Clean the pump

  1. Unplug the pump, then lift it out of the basin. Wear gloves if the basin is resin or fiberglass, since the edges can scrape.
  2. Rinse the intake cover or screen to remove debris, algae and hair.
  3. Pull out the impeller. On magnetic-drive pumps it slides out. Brush the impeller and the chamber with an old toothbrush.
  4. Soak scale off. For white scale, soak the parts in white vinegar, 50/50 with water or at full strength, for 1 to 12 hours. For heavy scale, use a calcium or lime remover made for fountains, following the label. Rinse thoroughly afterward.

Clear the tubing and nozzles

  • Flush the tubing, or clean it with a bottle brush or pipe cleaner.
  • Replace the tubing if it is slimy or has gone stiff.
  • Clear nozzle holes with a pin or toothpick.
  • Blow or flush the line if it is still blocked. Some people use compressed air, a shop vac or a hose nozzle. Do not force a flex line so hard that it splits.

When the pump hums but won’t move water

A humming pump is not always dead. For larger pond pumps, see pond pump not working. In most cases the impeller is seized by scale or debris. Clean it first. If it still will not turn, the impeller shaft may be broken. Those shafts are often ceramic and brittle. If cleaning does not solve it, replace the pump. Small fountain pumps often cost about $15 to $60, so a new one is usually cheaper than repeated repairs.

Reassemble and test

  1. Reassemble the pump and intake.
  2. Submerge the pump fully in the basin.
  3. Tilt the pump to purge trapped air.
  4. Plug it into a GFCI-protected outlet and watch the flow for a few minutes.

Prevent clogs

  • Clean the pump every 2 to 4 weeks, and the pre-filter more often in leafy spots.
  • Use a foam pre-filter over the intake.
  • Use distilled or rainwater in hard-water areas to slow scale.
  • Keep leaves out of the basin. Decaying leaves feed algae and clog intakes.

For the full cleaning routine, see fountain maintenance.

Drinking fountains are a different job

This guide is for garden and pond fountains. A drinking fountain, indoor or commercial, usually clogs in the drain or the trap under the basin, not in a pump. Follow the unit’s service manual, or call a plumber if you are not sure.

Common mistakes

  • Running the pump harder does not clear a clog. It can overheat the motor.
  • Using bleach to remove scale. Bleach does not dissolve scale. Vinegar or a fountain descaler does. Never mix vinegar or descalers with bleach.
  • Assuming a humming pump is dead. It is often just jammed.
  • Running the pump dry briefly. Even a short run can overheat it and crack seals or the shaft.

Safety

Never reach into the water or handle the pump while it is plugged in. Unplug first, every time.

If you are choosing a pump to replace a worn one, the small pond fountains guide covers sizing by pond volume and spray height.

The complete guide to water features

Simple Backyard Water Features: Types and Ideas
Read the guide

Keep exploring

Guides from other topics

All topics →