Pond Landscaping

Pond Shapes: Kidney, Round and Freeform Designs Compared

Compare kidney, round and freeform pond shapes: how each suits garden style, circulation and koi, plus liner sizing and volume formulas before you dig.

On this page
  1. Short answer
  2. Kidney ponds
  3. Round ponds
  4. Freeform ponds
  5. Square and rectangular formal ponds
  6. Shape and circulation
  7. Work out the liner size and volume
  8. Choose the spot, then lay out the shape

Short answer

Freeform and kidney shapes suit naturalistic gardens. Round, square and rectangular shapes suit formal or modern designs. For koi, a round or gently curved pond with a central bottom drain is easier to keep clean. Whatever shape you choose, keep the outline open enough for water to move across the whole pond.

Kidney ponds

Kidney ponds have a gentle curve that suits a natural garden. Put the waterfall at one end and the skimmer at the opposite end, so the flow runs the full length of the pond.

Avoid narrow necks and tight inlets. They create dead spots where debris and algae collect, and they are harder to clean.

Round ponds

A circle encloses the most area for its perimeter. That means less edging and good circulation for the money. Round ponds also suit koi: the fish can swim smoothly around the pond, and a central bottom drain collects waste efficiently. For koi planning in more detail, see koi pond landscaping ideas.

Freeform ponds

Freeform ponds suit naturalistic gardens and can fit an uneven site. They work best with fewer, broader curves. Many tight curves are harder to line and edge than a simple outline, and they waste liner.

Too many wiggles can look fussy, and they trap debris in the bends. Aim for a shape that looks deliberate from the house.

Square and rectangular formal ponds

Square and rectangular ponds suit formal gardens and modern designs. They need precise, level edges and straight lines. Small errors show far more than they do in a freeform design, so these ponds take more care to build.

Complex shapes can also be hard to build, and preformed shells limit your shape choices further.

Shape and circulation

Circulation depends on the outline as much as on the pump. Some practical steps:

  • Place the skimmer and the biological filter on opposite sides, so the water runs across the pond.
  • Avoid narrow arms and corners where water stalls.
  • In an irregular pond, add a jet or aerator to push water out of still zones.

Work out the liner size and volume

For a liner, add twice the maximum depth to the length, and twice the maximum depth to the width. Then add an overlap of roughly 1 to 2 feet (30 to 60 cm) in total. Check the final size with your liner supplier’s calculator.

To estimate how much water the pond holds, use these formulas:

  • Rectangle: length × width × depth (in feet) × 7.48 = US gallons
  • Round: 3.14 × radius² × depth (in feet) × 7.48 = US gallons
  • Irregular: length × width × average depth × about 6.7 = US gallons. This is an approximation.
  • Metric: length × width × depth (in metres) × 1,000 = litres

Choose the spot, then lay out the shape

Choose the spot before you choose the shape. Avoid low areas, where runoff collects and carries nutrients into the pond. Place the pond close to the house or main seating, so you can see it from inside as well as outside. For more on placement, see sun or shade for a garden pond.

Once you have a spot, mark the outline with a hose or rope. Walk around it, and look at it from the house and the main seating area before you dig. Make changes now, because digging is hard to undo.

If you are working on a small pond or a patio, small pond ideas for patios and balconies covers the shapes and containers that suit tight spaces.

Before you dig, call your utility locating service. In the US, dial 811 to have underground lines marked. For the dig itself, see how to build a garden pond.

The complete guide to pond landscaping

Backyard Pond Landscaping: Rocks, Planting and Layout
Read the guide

Keep exploring

Guides from other topics

All topics →