Short answer
Set a hard mowing strip of paving or brick, 6 to 12 inches (15 to 30 cm) wide, flush with the lawn. Point clippings away from the water. Do not feed or spray the lawn near the pond. Keep trimmers off the exposed liner.
A hard mowing strip
A mowing strip is a band of paving or bricks around the pond. Set it flush with the lawn, so the mower wheels ride on it. The strip keeps the mower away from the edge and reduces the risk of clippings and soil going into the water.
A raised edge or a low wall can also make mowing easier and keep clippings out of the pond.
Keep clippings out of the water
Clippings that fall into the pond decompose and add nitrogen and phosphorus. These nutrients feed algae, so a few clippings each mow can add up over a season.
- Point the mower’s side discharge away from the pond.
- Bag or mulch clippings near the water.
- Mow before you clean the skimmer, then empty it, so you do not clog the skimmer with fresh clippings.
No fertiliser or weedkiller nearby
Fertiliser and weedkiller both reach the water, through runoff and drift. Phosphorus in fertiliser feeds algae, and some herbicide formulations are toxic to fish.
Do not use weed-and-feed products near the pond. If you need to treat weeds, lift them by hand or use a method that does not reach the water.
Grade the lawn away from the pond
Grade the lawn so it slopes away from the pond, not toward it. This keeps runoff from carrying nutrients and soil into the water.
Turf right to the edge
If the turf runs right up to the pond, turn the liner up behind the turf, above the water line. Without this, soil can wick water out of the pond, and the liner can show as the soil settles.
Trimmers and robotic mowers
- String trimmers: these can nick or shred an exposed liner. Use hand shears, or a guard at the edge.
- Corded electric mowers and trimmers: keep them on RCD or GFCI protection near water.
- Robotic mowers: keep the boundary wire well back from the pond. Some models can drive into the water, so check the boundary setup carefully.
Buffers, wildlife and slopes
- Natural or larger ponds: keep an unmown or planted strip beside the water to filter runoff. A few feet is a minimum, and wider is better.
- Wildlife ponds: leave longer grass on one side as cover for frogs and newts.
- Slopes: avoid mowing slopes steeper than about 15 degrees, though this varies by mower. Terrace or plant steeper banks instead.
- Direction: on slopes, mow parallel to the pond edge. Never mow downhill toward the water.
For edge materials and the liner, see pond edging. For buffer planting, see plants around a pond. For power and cable safety around the pond, see hiding pond pumps, filters and cables.