Pond Building

Building a Pond on a Sloped Garden: Terracing and Retaining Walls

Build a pond on a slope by cutting, filling or terracing, with a level rim, a drained retaining wall and runoff diverted safely away from the pond.

On this page
  1. Why a slope changes the build
  2. Choose cut, fill or terrace
  3. Build a retaining wall that drains
  4. Level the rim
  5. Divert runoff before it reaches the water
  6. Build the pond step by step
  7. Streams and waterfalls
  8. Common questions
  9. Common mistakes
  10. Safety

Why a slope changes the build

A sloping garden does not stop you from building a pond, but it changes the order of the work. The water surface in a pond is always level, so the pond’s rim has to be level, even though the ground around it is not. The liner also cannot hold back a downhill bank on its own. Something solid has to take the load of the water and the soil behind it, whether that is a cut, a built-up berm or a retaining wall.

Runoff matters on a slope too. Water coming off higher ground can carry silt, fertiliser and pesticides into the pond, so plan how it will be diverted before you dig.

Choose cut, fill or terrace

There are three main ways to handle a slope:

  • Cut into the high side. Dig into the upper part of the slope and use the spoil to build up a low bank on the downhill side. This suits gentle slopes.
  • Cut and fill. Level a terrace by cutting the high side and filling the low side. Compact the fill in layers, usually 6 to 8 in (15 to 20 cm) thick, so it does not settle later.
  • Retaining wall on the downhill side. Build a wall to hold the pond and the soil behind it. This is the usual choice on steeper ground.

Do not put the pond’s deepest zone on loose fill. As the fill settles, it can pull the liner down and tear it. Put the deep part on undisturbed or fully compacted ground, and keep fill for the shallower shelves and the bank.

Build a retaining wall that drains

A retaining wall on the low side has to take the pressure of the soil and the water, and it needs drainage. Put gravel behind the wall, with a perforated pipe running along its base to carry groundwater away. Without drainage, water builds up behind the wall and pushes it over.

For walls built from segmental blocks, geogrid reinforcement is common once the wall is more than a few feet tall. Walls over about 3 to 4 ft often need a permit or an engineer’s sign-off, and the rules vary by area, so check with your local building office before you start.

Bury the first course of the wall below the finished ground, and keep the liner protected from the hard wall with underlay. The underlayment guide explains how to protect the liner where it meets stone or block.

Level the rim

Only the rim needs to be level. The water surface will sit level wherever it is in the pond, so you do not need to level the whole garden. Check the rim with a laser level, a water level (a clear tube filled with water), or a straightedge and spirit level.

A rim that is out by just 1 in (2.5 cm) will expose the liner on the high side. Check the rim several times as you work, and again after you fill the pond.

Divert runoff before it reaches the water

Stop water from running into the pond before it reaches the rim. A swale (a shallow ditch that follows the contour) or a French drain (a gravel trench with a perforated pipe) above the pond can collect runoff and carry it around. Without that, mud washes into the pond after every storm.

The overflow should exit on the downhill side, away from house foundations. The overflow article covers the set level, the pipe and where the water goes. For distances between a pond and a house, see the setback guide.

Build the pond step by step

  1. Survey the grade. Find the highest and lowest points, and mark where the water line will sit.
  2. Mark the outline and plan the terraces. Use a hose or rope to see how the shape sits on the slope.
  3. Excavate in stages. Cut the shelves, separating the topsoil from the subsoil so you can reuse the topsoil around the edges later.
  4. Build the wall or berm. Put in drainage, bury the first course, and compact the fill in lifts. Check each course is level as you build.
  5. Lay the underlay and liner. Clear the surface of sharp stones and roots first. The liners and sealants guide covers liner choice.
  6. Fill slowly and smooth the liner as the water rises. Trim the excess only after the pond is full.
  7. Finish the edges. Hide the liner with rounded stones, and make sure the overflow is set and working.

Streams and waterfalls

A slope suits a stream or waterfall better than a flat garden does, because gravity can carry the water down. A common layout puts a small header pool at the top, with a stream or drop running down to the main pond at the bottom. A gentle stream drop of about 1 to 2 in per foot gives a slow, quiet flow.

The lower pond has to hold the water that drains back from the stream when the pump is off. If the lower pond is too small, it overflows whenever the pump stops, so size it with that in mind.

Common questions

Do I need to level the whole garden?

No. Only the rim has to be level. The water surface sits level wherever the pond is, so the rest of the garden can keep its slope.

Can I just dig into the hill and line the hole?

Not on a steep slope. The liner cannot hold back the downhill bank, and an unsupported cut can collapse. You need a wall, a berm or a more gentle slope.

Where should the overflow go?

On the downhill side, away from the house foundations, and onto ground that can take the water. Do not let it run into a neighbour’s garden or toward a foundation.

Common mistakes

  • Levelling the whole garden when only the rim needs it.
  • Expecting the liner to hold a downhill bank by itself.
  • Backfilling without compacting it in layers.
  • Ignoring runoff from higher ground.
  • Letting the overflow discharge toward a foundation.

Safety

Unsupported cuts in a slope can collapse, so shore up or bench deep excavations rather than digging straight down into the bank. Wet clay is slippery and can slump, so avoid deep cuts in it. Call 811 (US) or check utility plans before digging, and keep gas and power lines in mind as you dig.

The complete guide to pond building

How to Build a Garden Pond: Planning, Digging and Design
Read the guide

Keep exploring

Guides from other topics

All topics →