A bog filter is a lined bed of planted gravel. Pond water is pumped into the bottom of the bed, rises through the gravel and leaves over an outlet back to the pond. Bacteria living on the gravel break down ammonia and nitrite, and the plants take up nitrate and phosphate. A bog filter is a useful biological filter, but it does not replace mechanical pre-filtration, and it is not maintenance-free.
How a bog filter works
- Pre-filtration. A skimmer, pre-filter basket or intake bay catches leaves and heavy fish waste before they reach the bed. Without it, the gravel clogs.
- Upflow distribution. The pump feeds a perforated pipe along the bottom of the bed.
- Biological conversion. Water moves slowly up through the gravel. Oxygen-loving bacteria on the gravel convert ammonia and nitrite into nitrate.
- Plant uptake. Marginal plants rooted in the gravel take up nitrate and phosphate as food.
- Return. Clean water leaves the bed over an outlet or spillway that sets the water level, and flows back to the pond by gravity.
Is a bog filter right for your pond?
A bog filter suits small wildlife ponds, lightly stocked ponds, and ponds that already have a mechanical filter. It is not a good fit as the only filter for a heavily stocked koi pond, because a small bog alone can’t carry that load.
Size the bog
Sizing is where sources disagree most. For a typical fish pond, the usual guide is about 10 to 20 percent of the pond’s surface area. Heavier fish loads, or a bog that is the only filter, call for 25 to 30 percent or more. Swimming ponds with a regeneration zone often use 30 to 50 percent.
Other guides give different numbers, and some measure against pond volume rather than surface area, so check which basis a figure uses. Start in the lower part of the range for a light fish load, and use the higher part for koi or where the bog is the only filter. Then test ammonia and nitrite through the first season, and add area if they keep climbing.
Build the bed
- Liner and separation. Use the same liner type as the pond, and separate the bed from the pond with a berm or wall.
- Gravel. Use washed, rounded pea gravel about 3/8 to 1/2 inch (10 to 12 mm). Keep out fines and soil. The bed should be about 12 to 18 inches (30 to 45 cm) deep.
- Limestone gravel. It raises pH and hardness, so avoid it unless you want that effect.
- Distribution pipe. Lay a perforated PVC manifold of 1.5 to 2 inches across the floor, with holes around 1/2 inch.
- Cleanout risers. Fit vertical risers at the ends of the manifold so you can flush out sludge.
- Water level. Keep the water about 1 to 2 inches below the gravel surface. This keeps the top of the bed dry, which limits algae and mosquitoes.
- Breather hole. Add a breather or anti-siphon hole in the pipework at the water line, so that switching off the pump doesn’t drain the bed.
Plants for a bog bed
Good choices include marsh marigold, pickerelweed, irises, sweet flag, watercress and canna. Plant them bare-root, pushed into the gravel, without soil.
- Avoid cattails in smaller beds. They spread aggressively and can pierce liners.
- Check invasive plant lists before you buy. Yellow flag iris, for example, is invasive in parts of the US.
- Expect a slow start. A bog bed takes about one growing season to settle in, and plant uptake drops sharply in winter.
Keep it working
A bog filter needs regular attention.
- Keep the pre-filter clean. Debris that gets past it settles in the gravel and speeds up clogging.
- Watch the flow. A drop in flow through the bed suggests clogging. Flush through the risers.
- Plan for sludge. Gravel slowly fills with sludge. Expect a flush or a partial dig-out after several years, though the timing varies.
- Remove dead plant material before it rots in the bed.
Common mistakes
- Using garden soil or compost. These release nutrients, feed algae and add loose organic matter that clogs the bed.
- Skipping pre-filtration. The gravel clogs quickly without it.
- Expecting a small bog to handle a heavy load. Pair it with a mechanical filter instead.
- Leaving no cleanout route. A neglected bed can turn anaerobic and smell of rotten eggs, which means it needs flushing.
- Planting invasives. Some plants sold as natural pond plants spread widely, so check local lists first.
For the mechanical stage in front of a bog, see pond skimmers. For how the bog fits into the wider system and how much flow it needs, see pond pump and filter setup. To keep the mechanical media clean, see cleaning a pond filter.