The clearest first clue is the water level. If your pond holds steady through a dry spell, with no rain or runoff, groundwater may be feeding it. A high water table or hidden drains can also keep a level steady, so use the tests below to confirm.
Watch the level through a dry spell
Over a few weeks with no rain, note the water level. Summer evaporation is often about 2.5–7.5 mm (0.1–0.3 in) a day, depending on climate. A level that holds steady against that loss suggests water is coming in.
Also check whether the overflow or spillway keeps running during a drought. A running overflow in dry weather points to a steady inflow.
Run a bucket test
- Fill a bucket with pond water.
- Set the bucket on a step or ledge inside the pond, so its water sits at about the same level as the pond.
- Mark the water level inside the bucket and the level outside it.
- Wait a few days with no rain.
- Compare the two levels.
If the pond falls less than the bucket, the pond is gaining water. If it falls about as much, the pond is probably not getting groundwater. If it falls more than the bucket, the pond may be leaking.
Map cold spots and winter open water
Groundwater stays close to the area’s average yearly air temperature. In temperate areas that is often around 10–15°C (50–60°F).
- In summer, look for cold spots, especially near the bottom or where water enters the pond. A thermometer on a pole or a temperature logger can help you map them. A cold layer near the bottom can also be a normal temperature layer, so don’t rely on it alone.
- In winter, look for patches of open water or thinner ice over the spring, since groundwater is above freezing.
Check the banks and bottom
- Wet banks and seeps. Look for wet ground, orange iron staining, or lush green growth along one edge during dry weather.
- Sand boils. These are small cones or circles of moving sand or silt on the bottom. They can show water rising from below.
Bubbles alone don’t prove a spring, since most bubbles are gas from decaying matter.
Test the water
Groundwater often has higher conductivity and hardness than rainwater. A TDS (total dissolved solids) meter can show the difference. Compare the reading with rainwater or tap water. A high reading is a clue, not proof.
Do a drawdown test
Pump the pond down by a set amount, then measure how fast it refills with no surface inflow. Run this test during a dry spell, so rain doesn’t skew the result. A fast refill with no rain or runoff suggests groundwater.
A spring vs a pond dug below the water table
A pond dug below the water table is groundwater-fed even without a distinct spring. Groundwater seeps in through the walls and floor. A true spring has a specific point where water clearly emerges. Either way, the water comes from the ground, but the difference matters if you plan changes to the water supply.
Common misconceptions
- “Bubbles mean a spring.” Most bubbles are gas from decaying matter, such as methane or carbon dioxide.
- “A steady level proves a spring.” A high water table, hidden drains or runoff can do the same.
- “Spring-fed ponds never get algae.” Groundwater can be high in nitrate or phosphate.
- “Spring-fed ponds never dry up.” Springs can weaken or stop during long droughts.
- “Spring water is always pure.” It can carry iron, nitrate or low oxygen.
Permits and safety
- Changing a spring or watercourse may need a permit, depending on where you live. Check with your local environmental or zoning authority before you alter the flow.
- Call your utility-locating service before digging. In the US, call 811.
- Sand boils and soft spring ground can be unstable underfoot. Don’t wade alone.
If you’re planning a spring-fed pond from scratch, see building a natural wildlife pond for the test pit and overflow steps.